SAE AMS2245B
- Tolerances Titanium and Titanium Alloy Extruded Bars, Rods, and Shapes
- standard by SAE International, 01/11/2017
- Category: SAE
$81.00
$41.00
This specification covers established inch/pound manufacturing tolerances applicable to titanium and titanium alloy extruded bars, rods, and shapes. These tolerances apply to all conditions, unless otherwise noted. The term "excl" applies only to the higher figure of the specified range.Extrusions shall be specified in either inch/pound units or SI units. When inch/pound unites are used, the tolerances shown for SI units are not applicable. When SI are used, the tolerances shwon for inch/pound units are not applicable.
PDF
All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.
Multi-User Access
After purchasing, you have the ability to assign each license to a specific user.
Printable
At any time, you are permitted to make printed copies for your and your members' reference use.
