ASTM C1368-10(2017)
- Standard Test Method for Determination of Slow Crack Growth Parameters of Advanced Ceramics by Constant Stress-Rate Strength Tes
- standard by ASTM International, 02/01/2017
- Category: ASTM
$65.00
$33.00
1.1 This test method covers the determination of slow crack growth (SCG) parameters of advanced ceramics by using constant stress-rate rectangular beam flexural testing, or ring-on-ring biaxial disk flexural testing, or direct tensile strength, in which strength is determined as a function of applied stress rate in a given environment at ambient temperature. The strength degradation exhibited with decreasing applied stress rate in a specified environment is the basis of this test method which enables the evaluation of slow crack growth parameters of a material.
Note 1: This test method is frequently referred to as “dynamic fatigue” testing (1-3)2 in which the term “fatigue” is used interchangeably with the term “slow crack growth.” To avoid possible confusion with the “fatigue” phenomenon of a material which occurs exclusively under cyclic loading, as defined in Terminology E1823, this test method uses the term “constant stress-rate testing” rather than “dynamic fatigue” testing.
PDF
All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.
Multi-User Access
After purchasing, you have the ability to assign each license to a specific user.
Printable
At any time, you are permitted to make printed copies for your and your members' reference use.
ASTM Section 10:2018
ASTM Book of Standards - Section 10 - Electrical Insulation and Electronics (Vols 10.01-10.04)..
$1,170.00 $2,740.00
ASTM Volume 11.02:2018
ASTM Book of Standards Volume 11.02: Water and Environmental Technology: Water (II)..
$372.00 $544.00
ASTM A1033-18
Standard Practice for Quantitative Measurement and Reporting of Hypoeutectoid Carbon and Low-Alloy S..
$27.00 $54.00
ASTM A90/A90M-13(2018)
Standard Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy..
$24.00 $48.00