AASHTO M 210-11
- Standard Specification for Use of Apparatus for the Determination of Length Change of Hardened Cement Paste, Mortar, and Concret
- standard by American Association of State and Highway Transporta
- Category: AASHTO
$40.00
$20.00
1. SCOPE
1.1. This practice covers the requirements for the apparatus and equipment used to prepare specimensfor the determination of length change in hardened cement paste, mortar, and concrete; theapparatus and equipment used for the determination of these length changes; and the proceduresfor its use.
1.2. Methods for the preparation and curing of test specimens, conditions of testing and curing,and detailed procedures for calculating and reporting test results are contained in applicabletest methods.
1.3. The values stated in SI units or inch-pound units are to be regarded as the standard. The values ineach system may not be exact equivalents; therefore, each system shall be used independently ofthe other. Combining values from the two systems may result in nonconformance with thestandard.
1.4. Values in SI units shall be obtained by measurement in SI units or by appropriate conversion,using the Rules for Conversion and Rounding given in IEEE/ASTM SI 10, of measurements madein other units.
1.1. This practice covers the requirements for the apparatus and equipment used to prepare specimensfor the determination of length change in hardened cement paste, mortar, and concrete; theapparatus and equipment used for the determination of these length changes; and the proceduresfor its use.
1.2. Methods for the preparation and curing of test specimens, conditions of testing and curing,and detailed procedures for calculating and reporting test results are contained in applicabletest methods.
1.3. The values stated in SI units or inch-pound units are to be regarded as the standard. The values ineach system may not be exact equivalents; therefore, each system shall be used independently ofthe other. Combining values from the two systems may result in nonconformance with thestandard.
1.4. Values in SI units shall be obtained by measurement in SI units or by appropriate conversion,using the Rules for Conversion and Rounding given in IEEE/ASTM SI 10, of measurements madein other units.
PDF
All of our standards document are available in PDF (Portable Document Format), an electronic, downloadable format.You will be able to download the file in your account downloads.
Multi-User Access
After purchasing, you have the ability to assign each license to a specific user.
Printable
At any time, you are permitted to make printed copies for your and your members' reference use.
